You can simply use this block and then tell the result if this works or not
Tried all possibilities, and it didn’t work !!!
Which component has this block ? When…on play ? Thanks
It’s a Notification Extension .
http://ullisroboterseite.de/android-AI2-MediaNotification.html
Ok. I will see it. But the on play block is one shot or continue to check ? Because you have a local variable to set , if the block starts always (like a clock always fires) the variable restarts always
The variable takes its value from the timer, and
The timer reads the position of the current position of the audio file, and then gives it to the variable, which saves this value , to be used when resuming, so it is given to the command ExoPlayer seek Position, but that command reads that value and does not change it and ExoPlayer plays the audio file from the beginning.
Thank you. I’ve tried this extension, but that developer says it needs to be upgraded, and not all of its functions are working. Also, in the same case, the Exoplayer Seek Position did not work.
Ok so , on play block start only to resume and then stops itself?
A position where the source file should start playing
means you need to use start block after using seek block
Like this
Try This and tell if this works
the block is seeking to that position but is not played ok got my point or not
Maybe this extension might help you
Did you look at the first picture!!!
Look at it again, the EXOPlayer Seek Position takes the variable value from the timer.
I appreciate your help. thank you very much all. But the extension supports Android 11 and above - and I have Android 10.
No it says that also works with android ≥ 11
>= , or <= ?
yes I did.
Off topic
i have no words left i have also made many attempts but it didn’t work