Padding ang Margin On CardView

[Don_Njondanmakal]

It will not look good in all devices

[Mika]

Use the decoration component

[Don_Njondanmakal]

@Mika Yes I used But Not Getting What I Want.

[Yoshi (KidKoder)]

What are these blocks? why you have such a writing like 0, -2, -14, -2

???

Yoshi

[Don_Njondanmakal]

Top,Left,Bottom…

[George_Loungos]

Try this

[Don_Njondanmakal]

@George_Loungos Thanks a lot i will check

[msr79526 (SR Official)]

Use this extention

Extension change the design of the button

[Don_Njondanmakal]

@msr79526 How is it possible.This extension is For Button.???

(Iam not Sure)

[Mika]

@Don_Njondanmakal

Yes I used But Not Getting What I Want.

You did not show any result. What is not working?
You should really provide something usefull instead to say “It’s not working…”

[Don_Njondanmakal]

I provide the code.Now I cannot show screenshot i will add.(Phone is now )

[msr79526 (SR Official)]

There was two extention on this topic.one for button one for arrangements

[nikzdreamer2001 (Nikhil Kumar Gupta)]

Designer Part

Blocks

AIA

TheLayout.aia (2.1 KB)

APK

TheLayout.apk (4.7 MB)

Result

Notes-

• in my example CornerRadius is 50.
• Margin bottom for card or any arrangement will be equal to negative of CornerRadius.
• margin left and right will be -10 as card automatically have margin of 10px.
• In above example i have taken VerticalArrangement2 whose margin bottom will be cornerRadius - 10 so that the amount of card that gone under screen will come up.

If this helps you mark it as solution…

[Don_Njondanmakal]

I will Check Brooo

[nikzdreamer2001 (Nikhil Kumar Gupta)]

Okay if that work for you mark it as solutions…

[Don_Njondanmakal]

Output With Your Code.

[Don_Njondanmakal]

Thanks @George_Loungos It Is Working

[nikzdreamer2001 (Nikhil Kumar Gupta)]

@nikzdreamer2001

In above example i have taken VerticalArrangement2 whose margin bottom will be cornerRadius - 10 so that the amount of card that gone under screen will come up.

have you followed this?

[Don_Njondanmakal]

i set Radius=20

[nikzdreamer2001 (Nikhil Kumar Gupta)]

according to this margin for card will be 0,-10,-20,-10 and for VerticaArrangement margin will be 0,0,10,0